Wed, 14 Mar 2012 21:38:32 +0800
hi,all:
I use naddress command to add ip to the vps
1. I have started a test vps with "--interface eth0:192.168.155.50/24",and I enter the
test vps,execute ifconfig:
eth0 Link encap:Ethernet HWaddr 78:2B:CB:02:2C:18
inet addr:192.168.155.50 Bcast:192.168.155.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:271309 errors:0 dropped:0 overruns:0 frame:0
TX packets:58440 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:124534819 (118.7 MiB) TX bytes:5267316 (5.0 MiB)
Interrupt:98 Memory:d6000000-d6012800
2. then I execute "naddress --set --nid 42 --ip 10.0.0.3/24",information on the console:
Adding 10.0.0.3
3.then I enter the test vps again,and execute ifconfig,
But now there is nothing output to the console,why?
Can I use the naddress to change the ip of the vps?
And how to give two or more ips to the vps?
Thank you!
3NMedia
hi,all:
I use naddress command to add ip to the vps
1. I have started a test vps with "--interface
eth0:192.168.155.50/24",and I enter the test vps,execute ifconfig:
eth0 Link encap:Ethernet HWaddr 78:2B:CB:02:2C:18
inet addr:192.168.155.50 Bcast:192.168.155.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:271309 errors:0 dropped:0 overruns:0 frame:0
TX packets:58440 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:124534819 (118.7 MiB) TX bytes:5267316 (5.0 MiB)
Interrupt:98 Memory:d6000000-d6012800
2. then I execute "naddress --set --nid 42
--ip 10.0.0.3/24",information on the console:
Adding 10.0.0.3
3.then I enter the test vps again,and execute
ifconfig,
But now there is nothing output to
the console,why?
Can I use the naddress to change the ip of the
vps?
And how to give two or more ips to the vps?
Thank you!